User Manual of Network Video Recorder
174
This chapter is applicable for DS-9600NI-RT series only.
10.1 Configuring Array and Virtual Disk
Purpose:
RAID (redundant array of independent disks) is a storage technology that combines multiple disk drive
components into a logical unit. A RAID setup stores data over multiple hard disk drives to provide enough
redundancy so that data can be recovered if one disk fails. Data is distributed across the drives in one of several
ways called "RAID levels", depending on what level of redundancy and performance is required. The
DS-9600NI-RT is capable of realizing Redundant Array of Independent Disk, supporting RAID0, RAID1, RAID5
and RAID10.
Before you start:
Please install the HDD(s) properly and it is recommended to use the same enterprise-level HDDs (including model
and capacity) for array creation and configuration so as to maintain reliable and stable running of the disks.
Introduction:
The DS-9600NI-RT series can store the data (such as record, picture, log information) in the HDD only after you
have created the virtual disk or you have configured network HDD (refer to Chapter12.2 Managing Network
HDD). Our device provides two ways for creating the virtual disk, including one-touch configuration and manual
configuration. The following flow chart shows the process of creating virtual disk.
Figure 10. 1 RAID Working Flow
To Next Page
Loading...
Need help?
General
