HIKVISION Network Video Recorder User Manual

User Manual of Network Video Recorder
182
10.2.2 Manually Rebuilding Array
Purpose:
If you do not enable the Auto-rebuild in Firmware Settings interface (Menu>HDD>RAID>Firmware) or the hot
spare disk has not been configured, then you can rebuild the array manually to restore the array when the virtual
disk is in Degraded status.
Steps:
1. Enter the Array Settings interface. The disk 3 is lost.
Menu > HDD > RAID > Array
Figure 10. 17 Array Settings Interface
2. Enter the Virtual Disk interface to check the status of the virtual disk. The virtual disk is in Degraded status.
Figure 10. 18 Virtual Disk Interface
3. Click Array tab to back to the Array Settings interface and click to configure the array rebuild.
At least one available physical disk should exist for rebuilding the array.
Figure 10. 19 Rebuild Array Interface
4. Select the available physical disk and click OK button to confirm to rebuild the array.

HIKVISION Network Video Recorder Specifications

General

Brand	HIKVISION
Model	Network Video Recorder
Category	Network Hardware
Language	English