2 Remote Operatio via the client
soft are
The Video Intercom module provides remote control and configuration on video
intercom products via the Safire Control Center AC client software.
2.1 Acti ate Device Remotely
You can only configu e and operate the indoor statio afte creatin a password for
the device acti ation
Before You Start
Default parameters of door statio are as follows:
•
Default IP Address: 192.0.0.64.
•
Default Port No.: 8000.
•
Default User Name: admin.
Steps
1.
Run the client soft are, enter Device Management, check the Online Device
area.
2.
Select an
inacti ated de
vice and click the Acti ate.
3.
Create a password, and confir the password.
Note
We highly recommend you to create a strong password of your own choosing
(using a minimum of 8 characters, including at least three kinds of following
categories: upper case lette s, lower case lette s, numbers, and special
characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security
system, resetti the password monthly or weekly can bette protect your
product.
4.
Click OK to acti
ate the device.
2.2 Device Management
Network Indoor
Statio
Configu atio Guide
16
To Next Page
Loading...
Need help?
General
