The MetaNeb® System Instructions for Use (174432 REV 10) 11
Assemble the Controller System
ASSEMBLE THE CONTROLLER SYSTEM
Make sure you have all the parts that are listed on the contents list.
STAND ASSEMBLY AND CONTROLLER INSTALLATION
Some older devices may have a different stand. For a stand that differs
from that shown, refer to the instructions that were supplied with the
stand.
If a two parts pole construction is used, make sure the two parts are fully
tightened to each other and there is no gap at the joint.
Installation of 183808 and 207384 Stands
To Next Page
Loading...
Need help?
General
