26 The MetaNeb® System Instructions for Use (174432 REV 10)
Cleaning
CLEANING
To help prevent injury and/or equipment damage, obey these warnings
and cleaning instructions:
• Warning—Failure to discard the SPU circuit in accordance with
facility protocol could cause the spread of infection.
• Warning—Do not steam clean the controller, stand, or circuit.
• Warning—Do not expose the unit to excessive moisture.
• Warning—Do not use harsh cleansers, solvents, or detergents.
• Warning—Failure to follow the cleaner manufacturers instructions
could cause equipment damage.
• Warning—Do not use phenolic, alcohol, quaternary ammonium
chloride, or bleach solutions to clean the patient circuit. Use these
solutions to clean the controller only.
The Metaneb® Controller has been tested for compatibility with these
cleaning and disinfecting solutions:
CLEANING THE CONTROLLER AND STAND
Clean the controller and stand between patients, when visibly soiled, or
according to facility protocols. Do not spray the cleaner on to the
controller. We recommend that you clean the controller and stand with a
soft cotton cleaning pad that is moistened with the cleaner.
Do not use excessive liquid or harsh cleansers. Do not immerse the
controller in water or let liquids enter the controller.
Clean the controller and stand as follows:
1. Make sure the air supply hose is connected to the controller.
2. Make sure a circuit is connected.
3. Wipe down the controller or stand with the moistened cloth.
Chemical Class Active Ingredient
Phenolic Ortho-Phenylphenol
Ortho-Benzyl-para-Chlorophenol
Alcohol Isopropyl alcohol
Quaternary ammonium
chloride
Didecyl Dimethyl Ammonium Chloride
Alkyl Dimethyl Benzyl Ammonium Chloride
Bleach
Sodium Hypochlorite
To Next Page
Loading...
Need help?
General
