Digital Video Recorder User Manual
72
Enable H.264+/265+ for all the analog cameras.
6.6 RS-232 Settings
Steps
Note
This function is only available for certain models.
1. Go to Configuration → RS-232.
2. Configure RS-232 parameters, including baud rate, data bit, stop bit, parity, flow control and
usage.
Console
Connect a computer to the video recorder through the computer serial port. Video recorder
parameters can be configured by using software such as HyperTerminal. The serial port
parameters must be the same as those of video recorder when connecting with the computer
serial port.
Transparent Channel
Connect a serial device directly to the video recorder. The serial device will be controlled
remotely by the computer through the network and the protocol of the serial device.
3. Click Apply.
To Next Page
Loading...
