16 English
5.2.2 Adjusting the guard
DANGER
Risk of injury. Flying fragments or sparks could cause injury.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
5.2.3 Conversion from normal cutting to flush cutting
The front section of the saw arm can be converted to allow flush cuts to be made (e.g. as close as
possible to edges and walls).
▶ If you wish to use the product in the flush cutting position, have the product converted by Hilti Service.
5.3 Locking rotary movement of the guide wheels
WARNING
Risk of injury. The saw could move inadvertently or fall down.
▶ When working on roofs, scaffolds and/or on slightly sloping ground or surfaces, always take steps to
prevent rotation of the guide wheels when the saw is not in use.
1. Release the guide wheel mounting screws and remove the guide wheels.
2. Reverse the guide wheels (turn through 180°) and refit the mounting screws.
◁ The integrated locking function is active.
3. Check that the guide wheels are securely fastened.
Printed: 24.04.2018 | Doc-Nr: PUB / 5265931 / 000 / 02
To Next Page
Loading...
