Why the LEDs on my Hilti Saw indicate nothing?
If the LEDs on your Hilti Saw aren't lighting up, it could be due to the following reasons: * The battery is not fully inserted. Push the battery in until it engages with a double click. * The battery is discharged. Replace the battery and charge the empty one.
How to fix Hilti SCM 22-A if chips fall onto the base plate?
If chips or cuttings from your Hilti Saw are not being transported into the chip collector and are falling onto the base plate, it could be because: * The chip collector is full. Empty the chip collector. * The chip ejector channel is blocked. Clean the chip ejector channel.
What to do if 4 LEDs blink on my Hilti SCM 22-A Saw?
If 4 LEDs are blinking on your Hilti Saw, it could be because the circular saw was overloaded briefly. Release the control switch and then press it again. Alternatively, the overheating prevention cut-out may have been activated. Allow the circular saw to cool down and clean the air vents.
Why does the saw blade stall on my Hilti SCM 22-A Saw?
The saw blade stalls because the saw advance pressure is too high. Reduce advance pressure and switch the product back on.
Why is my Hilti Power Tool circular saw or battery getting so hot?
If your Hilti Power Tool's circular saw or battery is getting very hot, immediately switch off the circular saw, remove the battery, and keep it under observation, allowing it to cool down. This could be due to an electrical fault or because the product is overloaded, exceeding its application limits. Pay attention to the power and performance rating of the product before using it, and check its suitability for the job.
Why does the running speed drop on my Hilti SCM 22-A Saw?
If the running speed of your Hilti Saw suddenly drops, it could be because the saw blade is jamming. Make sure not to tilt the saw blade.
How to fix Hilti SCM 22-A battery not engaging with double click?
If the battery isn't engaging with a double click on your Hilti Saw, the retaining lugs on the battery may be dirty. Clean the retaining lugs and refit the battery.
Why are 4 LEDs blinking on my Hilti SCM 22-A Saw?
If you notice 4 LEDs blinking on your Hilti Saw, it could mean one of two things: either the circular saw was briefly overloaded, in which case you should release the control switch and press it again, or the overheating prevention cut-out has been activated. If it's the latter, allow the circular saw to cool down and clean the air vents.
Why doesn't the battery engage with a double click on my Hilti SCM 22-A?
If the battery does not engage with an audible "double click" on your Hilti Saw, it could be because the retaining lugs on the battery are dirty. Clean the retaining lugs and refit the battery.
What to do if the LEDs indicate nothing on my Hilti SCM 22-A Saw?
If the LEDs on your Hilti Saw don't light up, it could be due to a couple of reasons. First, make sure the battery is fully inserted until you hear a double click. If that's not the issue, the battery might be discharged. In that case, try swapping it with a charged battery.
To Next Page
General
