6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first
time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are
clean and dry before inserting it in the corresponding
charger.
Read the operating instructions for the charger for
further information about the charging procedure.
Lithium-ion battery packs are ready to use at any time,
even when only partially charged. Charging progress
is indicated by the LED display (see charger operating
instructions).
6.3 Fitting the battery
CAUTION
Before fitting the battery, check that the power
tool is switched off and the switch-on interlock is
activated (not pressed). Use only the Hilti batteries
approved for use with this power tool.
CAUTION
Check that the terminals on the battery and in the
power tool are free from foreign objects before
inserting the battery in the power tool.
1. Push the battery into the power tool from the
rear as far as it will go and until it is heard to
engage with a double click.
2. CAUTION A falling battery may present a risk
of injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.4 Removing the battery from the power tool
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (work-
ing position) and move it into the first latching position
(transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts
of the battery pack are not short-circuited. Remove
loose metal parts such as screws, nails, clamps,
loose screw bits, wires or metal swarf from the case,
toolbox or transport container, or prevent these parts
from coming into contact with the battery packs.
Observe national and international transport regula-
tions when shipping battery packs (transportation by
road, rail, sea or air).
7. Operation
NOTE
If the blade has jammed, the tool will not restart by
itself when the pressure applied to it is removed. The
switch-on interlock and the on/off button must be
pressed again.
CAUTION
Wear protective gloves. The cutting edges of the
saw blade teeth are sharp. The cutting edges present
a risk of injury.
CAUTION
Wear protective glasses and a dust mask. The
sawing operation swirls up dust and chips into the
air. The dust and chips may be harmful to the eyes
and respiratory system.
CAUTION
Wear ear protectors. The power tool and the sawing
operation generate noise. Exposure to noise can cause
loss of hearing.
7.1 Changing the saw blade
CAUTION
Wear protective gloves when changing insert tools.
The tool, the clamping flange and the clamping screw
get hot.
CAUTION
Check that the blade to be fitted complies with
the technical requirements and that it is well
en
28
To Next Page
Loading...
Need help?
General
Weight and Dimensions
