*2125998*
2125998 English 9
Status Meaning
1 LED blinks. • Charge status: < 10 %
Battery charge status cannot be displayed while the control switch is
pressed.
3.4 Overload and overheating protection
The power tool is equipped with an electronic system to protect against
overloading and overheating. The power tool switches itself off automatically
in the event of overloading or overheating. After releasing the control switch,
the power tool may not restart immediately when the switch is pressed again
(while the power tool is cooling down).
Overloading or overheating are not indicated by the charge status
display.
3.5 Items supplied
Hammer drill / driver, operating instructions.
Other system products approved for use with this product can be found
at your local Hilti Store or online at: www.hilti.group.
4 Technical data
4.1 Technical data
Rated voltage
10.8 V
Weight in accordance with EPTA procedure 01
1.2 kg
Speed 1st gear
0 /min … 400 /min
2nd gear
0 /min … 1,500 /min
Torque (soft joint)
≤ 12 Nm
Torque range (15 settings)
0.5 Nm … 3.5 Nm
Keyless chuck clamping range
0.8 mm … 10 mm
Ø drill bit (softwood)
0.8 mm … 14 mm
Ø drill bit (hardwood)
0.8 mm … 10 mm
Ø drill bit (metal)
0.8 mm … 6 mm
4.2 Battery
Battery operating voltage
10.8 V
Ambient temperature
−17 ℃ … 60 ℃
Storage temperature
−20 ℃ … 40 ℃
Charging temperature
−10 ℃ … 60 ℃
Printed: 19.06.2019 | Doc-Nr: PUB / 5251744 / 000 / 02
To Next Page
Loading...
Need help?
General
