How to release a stuck chisel from the Hilti TE 1000-AVR Power Tool chuck?
If the chisel cannot be released from the chuck of your Hilti Power Tool, it might be because the chuck is not pulled back fully. Pull the chuck back as far as it will go and remove the insert tool.
General| Weight | 12.5 kg |
|---|---|
| Impact Energy | 26 J |
| Vibration Reduction | Yes |
| Tool Holder | TE-S |
| Weight according to EPTA Procedure 01/2003 | 12.5 kg |
| Full hammering frequency | 1950 impacts/minute |
| Power Source | Corded Electric |
| Voltage | 230 V |
| Blows per Minute | 1950 bpm |
| Dust removal system available | Yes |
| Impact Rate | 1950 impacts/minute |
Explains the meaning of DANGER, WARNING, CAUTION, and NOTE in safety instructions.
Explains the active vibration reduction system and protective features against damage and shock.
Covers overall safety advice, including warnings about following instructions and keeping the manual.
Details critical safety measures related to power cords, grounding, water exposure, and RCDs.
Outlines precautions for staying alert, using PPE, preventing unintentional starting, and proper attire.
Covers switching on/off, adjusting power, chiseling at low temperatures, and general chiseling techniques.
Provides specific advice on starting chiseling, direction, self-sharpening, depth, and contact pressure.
Lists common power tool issues, their possible causes, and recommended remedies.
Addresses further issues like generator sleep mode, cold operation, voltage problems, and tool unlocking.
To Next Page
