Why Hilti TE 3-C Rotary Hammer doesn't achieve full power?
If your Hilti Rotary Hammer isn't reaching its full power, the issue might be with the extension cord. Ensure you are using an extension cord that has an adequate conductor cross section to provide sufficient power to the tool.
What to do if my Hilti Rotary Hammer has no hammering action?
If your Hilti Rotary Hammer isn't hammering, there could be a couple of reasons: 1. **Tool is too cold:** Try bringing the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. If necessary, repeat the procedure until the hammering mechanism begins to operate. 2. **Function selector switch:** Check that the function selector switch is set to the “Hammer drilling” position and not “Rotary drilling only”.
General| Drilling | Yes |
|---|---|
| Chuck type | SDS Plus |
| Product color | Black, Red |
| Country of origin | Germany |
| Input power | 850 W |
| Power source | AC |
| Power plug type | Type C |
| Impact rate | 5160 bpm |
| Rated speed (max) | 1300 RPM |
| Impact energy (max) | 2.5 J |
| Vibration level (hammer drilling) | 15.5 m/s² |
| Drilling diameter in concrete (max) | 28 mm |
| Optimum drilling diameter (concrete) | 6 - 16 mm |
| Noise level | 92 dB |
| Number of shipping (inner) cases per master (outer) case | 1 pc(s) |
Weight and Dimensions| Weight | 3000 g |
|---|---|
| Package depth | 3456 mm |
| Package width | 2000 mm |
| Package height | 4500 mm |
| Package weight | 4500 g |
To Next Page
