Hilti TE 3-C Original Operating Instruction

2 English 2121609
*2121609*
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols can be used on the product:
Wireless data transfer
Drilling without hammer action
Drilling with hammering action (hammer drilling)
Forward / reverse
Protection class II (double-insulated)
Rated speed under no load
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Rotary hammer TE 3M
TE 3C
Generation 01
Serial no.
1.5 Declaration of conformity
TE 3-C
We declare, on our sole responsibility, that the product described here complies with the applicable
directives and standards. A copy of the declaration of conformity can be found at the end of this
documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2 Safety
2.1 Safety instructions
The safety rules given in the following section contain all general safety rules for electric tools which, in
accordance with the applicable standards, require to be listed in the operating instructions. Accordingly,
some of the rules listed may not be relevant to this electric tool.
2.1.1 General power tool safety warnings
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
▶ Keep work area clean and well lit. Cluttered or dark areas invite accidents.

Hilti TE 3-C Specifications

General

Drilling	Yes
Chuck type	SDS Plus
Product color	Black, Red
Country of origin	Germany
Input power	850 W
Power source	AC
Power plug type	Type C
Impact rate	5160 bpm
Rated speed (max)	1300 RPM
Impact energy (max)	2.5 J
Vibration level (hammer drilling)	15.5 m/s²
Drilling diameter in concrete (max)	28 mm
Optimum drilling diameter (concrete)	6 - 16 mm
Noise level	92 dB
Number of shipping (inner) cases per master (outer) case	1 pc(s)

Weight and Dimensions

Weight	3000 g
Package depth	3456 mm
Package width	2000 mm
Package height	4500 mm
Package weight	4500 g