10 English
2. Push the accessory tool into the chuck as far as it will go, turning it and
applying light pressure until it engages with an audible click.
3. After fitting the accessory tool, grip it and pull it firmly in order to check
that it is securely engaged.
◁ The product is ready for use.
6.1.6 Removing the accessory tool 5
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
▶ Pull the chuck ring back as far as it will go and remove the accessory tool.
6.2 Types of work
WARNING
A damaged supply cord presents a hazard! Do not touch the supply
cord or extension cord if damaged while working. Disconnect the supply
cord plug from the power outlet.
▶ Check the appliance’s supply cord at regular intervals and have it
replaced by a qualified specialist if found to be damaged.
Check extension cords at regular intervals and replace them if found to be
damaged.
6.2.1 Function selector switch 6
▶ Set the function selector switch to the desired working position.
◁ Do not operate the function selector switch while the motor is running.
Risk of damage!
6.2.2 Drilling without hammering 6
▶ Set the function selector switch to this symbol: .
6.2.3 Drilling with hammering action (hammer drilling) 6
▶ Set the function selector switch to this symbol: .
6.2.4 Positioning the chisel (only TE 30-AVR) 6
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to “Chisel
positioning”. Turn the function selector switch until it engages in the
“Chiseling” position.
Printed: 03.03.2017 | Doc-Nr: PUB / 5324643 / 000 / 01
To Next Page
Loading...
Need help?
General
