Hilti TE 4-A22 - Fitting the battery; Removing the battery; Fitting the accessory tool

10 English
5.1.2 Fitting the battery
1. Push the battery into the battery interface on the tool until it is heard to engage with a click.
2. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.1.4 Fitting the accessory tool
1. Apply a little grease to the connection end of the accessory tool.
➥ Use only the recommended grease supplied by Hilti. Use of the wrong grease can result in damage
to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
Printed: 10.04.2019 | Doc-Nr: PUB / 5200339 / 000 / 03