Hilti TE 4-A22 - Removing the accessory tool; Fitting the depth gauge (optional); Types of work

English 11
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
➥ The product is ready for use.
5.1.5 Removing the accessory tool
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.1.6 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
5.2 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function selection during operation.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Direction of rotation
▶ Set the direction of rotation.
➥ The selector switch engages in this position.
Printed: 10.04.2019 | Doc-Nr: PUB / 5200339 / 000 / 03