Hilti TE 50-AVR Manual

8 English 2102964
*2102964*
5.3 Chisel positioning 7
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to “Chisel positioning”. Turn the function selector
switch until it engages in the “Chiseling” position.
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
1.
Set the function selector switch to the “Chisel positioning” position .
2. Rotate the chisel to the desired position.
3.
Turn the function selector switch until it engages in the “Chiseling” position.
➥ The product is ready for use.
5.3.1 Chiseling 8
▶
Set the function selector switch to the “Chiseling” position .
5.3.2 Switching sustained operation on and off 9
When chiseling, the on/off switch can be locked in the “on” position.
1. Push the lockbutton for continuous operation forward.
2. Press the on/off switch as far as it will go.
➥ The product then runs in sustained operating mode.
3. Push the lockbutton for continuous operation back.
➥ The product switches off.
6 Detachable supply cord
6.1 Connecting the detachable supply cord
CAUTION
Risk of injury! Due to leakage current as a result of dirty contacts.
▶ Connect the detachable electric connector to the electric tool only when it is clean and dry and when the
supply cord is unplugged from the power outlet.
1. Push the keyed, detachable electric plug connector into the socket as far as it will go, until it is heard to
engage.
2. Plug the supply cord into the power outlet.
6.2 Disconnecting the detachable supply cord
1. Unplug the supply cord from the power outlet.
2. Press the release button and pull the keyed, detachable electric plug connector out of the socket.
3. Pull the supply cord connector out of the power tool.
7 Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
Printed: 12.12.2018 | Doc-Nr: PUB / 5283577 / 000 / 02

Hilti TE 50-AVR Specifications

General

Drilling	Yes
Chuck type	SDS Max
Product color	Black, Red
Country of origin	Germany
Impact rate	3180 bpm
Rated speed (max)	360 RPM
Impact energy (max)	6 J
Vibration level (hammer drilling)	9 m/s²
Drilling diameter in concrete (max)	40 mm
Optimum drilling diameter (concrete)	16 - 32 mm
Input power	1100 W
Power source	AC
Power plug type	Type C
Noise level	108 dB
Quantity per shipping (inner) case	1 pc(s)

Weight and Dimensions

Weight	6100 g
Package depth	3456 mm
Package width	2000 mm
Package height	4500 mm
Package weight	4500 g