10 English 2102964
*2102964*
Trouble or fault Possible cause Action to be taken
The drill bit can’t be released. The chuck is not pulled back fully. ▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
The side handle is not fitted cor-
rectly.
▶ Release the side handle and refit
it correctly so that the clamping
band and side handle engage in
the recess.
The service indicator lights
after changing the carbon
brushes.
The contact surfaces are not yet
run in.
▶ Run in the carbon brushes by
allowing the power tool to run
under no load for at least 1
minute without interruption.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r4902202.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 12.12.2018 | Doc-Nr: PUB / 5283577 / 000 / 02
To Next Page
Loading...
Need help?
General
Weight and Dimensions
