What to do if Hilti Drill doesn't start and service indicator is red?
If your Hilti Drill does not start and the service indicator shows red, the carbon brushes may be worn out. Have the power tool checked by a trained electrical specialist, and have the carbon brushes replaced if needed. Alternatively, there could be an electrical fault. Have the tool checked by Hilti Service.
How to fix Hilti Drill that doesn't start?
If your Hilti Drill doesn't start, there could be several reasons: * There might be an interruption in the electric supply. To check this, plug in another power tool or appliance to see if it works. * The supply cord or plug could be defective. In this case, have a trained electrical specialist check and replace it if necessary. * The generator might be in sleep mode. Apply a load to the generator by connecting a second power consumer, such as a work light. * There could be an electrical fault. Have the power tool and supply cables checked by a trained electrical specialist. * The electronic restart interlock may be activated after an interruption in the electric supply. Try switching the power tool off and then on again.
What to do if the drill bit doesn't rotate on my Hilti Drill?
If the drill bit on your Hilti Drill isn’t rotating, check that the function selector switch is set to the 'Hammer drilling' position. Also, ensure that the chuck is pulled back as far as it will go to properly release and remove the accessory tool.
General| Drilling | Yes |
|---|---|
| Chuck type | SDS Max |
| Product color | Black, Red |
| Country of origin | Germany |
| Impact rate | 3180 bpm |
| Rated speed (max) | 360 RPM |
| Impact energy (max) | 6 J |
| Vibration level (hammer drilling) | 9 m/s² |
| Drilling diameter in concrete (max) | 40 mm |
| Optimum drilling diameter (concrete) | 16 - 32 mm |
| Input power | 1100 W |
| Power source | AC |
| Power plug type | Type C |
| Noise level | 108 dB |
| Quantity per shipping (inner) case | 1 pc(s) |
Weight and Dimensions| Weight | 6100 g |
|---|---|
| Package depth | 3456 mm |
| Package width | 2000 mm |
| Package height | 4500 mm |
| Package weight | 4500 g |
Essential safety precautions for operating power tools, covering work area and electrical safety.
Personal safety precautions to prevent injury during operation.
Guidelines for proper use, maintenance, and storage of the power tool.
Specific safety advice for hammer-related operations.
Further safety measures including personal, electrical, and handling advice.
Specifies the approved applications and operational conditions for the product.
Procedure for inserting and removing accessory tools.
Details different work modes like drilling and chiseling.
Table of common problems, their causes, and solutions.
To Next Page
