Power tool TE 6‑A36
Speed under no load in hammer drilling mode
1,040/min
Single impact energy
2.0 J
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a
preliminary assessment of exposure. The declared vibration emission level represents the main applications of
the tool. However if the tool is used for different applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly increase the exposure level over the total working
period. An estimation of the level of exposure to vibration should also take into account the times when the
tool is switched off or when it is running but not actually doing the job. This may significantly reduce the
exposure level over the total working period. Identify additional safety measures to protect the operator from
the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
Noise and vibration information (measured in accordance with EN 60745‑2‑6):
Typical A-weighted sound power level 99 dB (A)
Typical A-weighted emission sound pressure level. 88 dB (A)
Uncertainty for the given sound level
3 dB (A)
Triaxial vibration values (vibration vector sum) Measured in accordance with EN 60745‑2‑6
Hammer drilling in concrete, a
h, HD
9 m/s²
Drilling in metal, a
h, D
< 2.5 m/s²
Uncertainty (K) for triaxial vibration value
1.5 m/s²
Other information about the power tool
Chuck TE‑C Click
Battery B 36/2.4 Li‑ion B 36/2.6 Li‑ion B 36/3.0 Li‑ion B 36/3.3 Li‑ion B 36/3.9 Li‑ion
Rated voltage 36 V 36 V 36 V 36 V 36 V
Capacity
2.4 Ah 2.6 Ah 3.0 Ah 3.3 Ah 3.9 Ah
Energy capacity 86.4 Wh 93.6 Wh 108.0 Wh 118.8 Wh 140.4 Wh
Weight 1.17 kg 1.17 kg 1.17 kg 1.6 kg 1.65 kg
Type of cell
Li‑ion Li‑ion Li‑ion Li‑ion Li‑ion
Temperature
monitoring
NTC NTC NTC NTC NTC
Deep discharge
protection
Yes Yes Yes Yes Yes
5. Safety instructions
NOTE
The safety rules in section 5.1 contain all general
safety rules for power tools which, in accordance
with the applicable standards, require to be listed in
the operating instructions. Accordingly, some of the
rules listed may not be relevant to this tool.
5.1 General power tool safety warnings
WARNING! Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious in-
jury. Save all warnings and instructions for future
en
5
To Next Page
Loading...
