8 English 2063039
*2063039*
▶ The tool may be operated only when connected to a power source
providing a voltage and frequency in compliance with the information
given on the type identification plate.
3.3 AVR option
The product may be optionally equipped with an Active Vibration Reduction
(AVR) system, which reduces vibration noticeably.
3.4 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-
acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about
its own axis in the opposite direction. ATC detects this sudden pivoting
movement of the power tool and switches the tool off immediately.
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by
releasing the control switch for a moment and then pressing the switch
again.
3.5 Service indicator
The product is equipped with a service indicator LED.
3.5.1 Service indicator status
Status Meaning
The service indicator lights red. End of service interval – servicing is
due.
The service indicator blinks red. Have the combihammer repaired by
Hilti Service.
3.6 Items supplied
Combihammer, side handle, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group | USA: www.hilti.com
4 Technical data
For rated voltage, rated current, frequency and/or input power, refer to
the country-specific type identification plate.
If the tool is powered by a generator or transformer, the generator or
transformer’s power output must be at least twice the rated input power
shown on the rating plate of the tool. The operating voltage of the transformer
Printed: 30.08.2019 | Doc-Nr: PUB / 5150793 / 000 / 02
To Next Page
Loading...
Need help?
General
