23
en
11. Warranty
Hilti warrants that the product supplied is free of defects
in material and workmanship. This warranty is valid as
long as the product is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti operating instructions, all warranty claims are
made within 12 months (unless other mandatory national
regulations prescribe a longer minimum period) from
the date of sale (invoice date) and the technical sys-
tem is maintained, i.e. only original Hilti consumables,
accessories and spare parts are used with the prod-
uct.
This warranty provides the free-of-charge repair or
replacement of defective parts only. Parts requiring
repair or replacement as a result of normal wear and
tear are not covered by this warranty.
Additional claims are excluded, unless mandatory
national regulations prohibit such exclusion. In par-
ticular, Hilti is not obligated for direct, indirect, inci-
dental or consequential damages, losses or expenses
in connection with, or by reason of, the use of, or
inability to use the product for any purpose. Implied
warranties of merchantability or fitness for a partic-
ular purpose are specifically excluded.
Send the product and/or related parts immediately
upon discovery of a defect to the local Hilti marketing
organization for repair or replacement.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
10. Disposal
Most of the materials from which Hilti electric tools are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti rep-
resentative for further information.
Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows: Dis-
mantle the electric tool as far as possible without the need for special tools. Use absorbent paper to wipe oily
parts clean and to collect any grease that runs out (total quantity approx. 50 ml). This paper should also be
disposed of correctly. On no account should grease be allowed to enter the waste water system or to find
its way into the ground.
The individual parts should be separated as follows:
Part/assembly Main material Recycling
Toolbox Plastic Plastics recycling
Gear housing Aluminium alloy Scrap metal
Bearing plate Aluminium alloy Scrap metal
Grip, side handle Plastic Plastics recycling
Motor housing Plastic Plastics recycling
Grip cover Plastic Plastics recycling
Fan Plastic Plastics recycling
Motor (rotor and stator) Steel and copper Scrap metal
Supply cord Copper, synthetic rubber Scrap metal
Gearing parts Steel Scrap metal
Hammering mechanism parts Steel Scrap metal
Screws, small parts Steel Scrap metal
To Next Page
Loading...
Need help?
General
