19
Software version
Embedded software: 1.0
PC software: 1.0
* There is not further notice if product specification changes.
Chapter 7 EMC information
This product needs special precautions regarding EMC and needs to be installed and put
into service according to the EMC information provided, and this unit can be affected by
portable and mobile RF communications equipment.
Do not use a mobile phone or other devices that emit electromagnetic fields, near
the unit. This may result in incorrect operation of the unit.
Caution: This unit has been thoroughly tested and inspected to assure proper
performance and operation!
Caution: this machine should not be used adjacent to or stacked with other
equipment and that if adjacent or stacked use is necessary, this machine should be
observed to verify normal operation in the configuration in which it will be used.
Guidance and manufacture’s declaration – electromagnetic emission
The WBP-03D is intended for use in the electromagnetic environment specified below. The customer of
the user of the WBP-03D should assure that it is used in such an environment.
Emission test Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11
Group 1
The WBP-03D use RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emission
CISPR 11
Class B
The WBP-03D is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
Harmonic emissions
To Next Page
