20
Installing/Replacing the Battery
2.2 Installing/Replacing the Battery
Before using the instrument for the rst time, install a layered-type
alkaline battery (6LR61) or a layered-type manganese dry cell
battery (6F22). Also, before doing measurement, check that there
is adequate remaining power in the battery. If there is not, replace
the battery.
WARNING
• Battery may explode if mistreated. Do not short
circuit, recharge, disassemble or dispose of in re.
• To avoid electric shock, remove the jaws from the
object to be measured, and remove the rear cover,
before replacing the battery.
• Also, before using the instrument after replacing
the battery, fasten the rear cover with its screws.
• To avoid damage to the instrument or electric
shock accidents, use only the screws that came
with the instrument to fasten the rear cover in
place. If you lose or damage the screws, contact
your authorized Hioki distributor or reseller.
• Handle and dispose of batteries in accordance
with local regulations.
To Next Page
Loading...
