Hioki 3283-20 - Setting a slower display update rate (SLOW); Setting a faster display update rate (FAST)

30
Measuring Leakage Current
Setting a slower display update rate (SLOW)
If the displayed current value uctuates rapidly and is hard to read, you
can set a slower update rate (approx. 1 time/3 seconds) by pressing the
SLOW/Hz key, to make the value easier to read.
[SLOW]
[Hz]
[RMS]
• Setting [Hz] or [RMS] will return the display to the normal update
rate.
• With the frequency display, the update rate cannot be changed.
Setting a faster display update rate (FAST)
A faster rate of approximately 4 times per second can be set for
the display update. This is useful for example to measure load
currents with intense uctuations and in similar applications.
NORMAL
Press twice in
succession
FAST (Split-second display each
time key is pressed)
If you switch to [SLOW] display while the instrument is in the fast
mode, the display update rate will be the same as [NORMAL]
(approx. 2 times/second).