How to fix Hioki 8847 Camcorder when keys do not work?
If the keys on your Hioki Camcorder are not working, first, check if any key is being held down. Also, verify if the key-lock state is active, indicated by a Key-Lock message on the display. To resolve this, ensure that no keys are pressed and deactivate the key-lock state by holding the CURSOR keys for three seconds.
Why Hioki 8847 display does not appear when turned on?
If the display of your Hioki Camcorder does not appear when you turn it on, the issue might be with the power connection. Verify that the power cord is properly connected.
What to do if no changes occur in displayed waveform on Hioki Camcorder?
If no changes occur in the displayed waveform on your Hioki Camcorder, the clamp sensor or connection cable might not be correctly connected, the vertical axis (voltage axis) range might not be properly set, or the low-pass filter could be enabled. Verify that the clamp sensor or connection cable is correctly connected and check the input channel settings.
What to do if Hioki 8847 Camcorder screen is blank?
If you are seeing a blank screen on your Hioki Camcorder, the backlight saver might be active. Press any key to check. To resolve this, turn the backlight saver off.
Why waveform does not appear when I press START key on Hioki Camcorder?
If a waveform does not appear when you press the START key on your Hioki Camcorder, the “Pre-Trigger wait” or “Trigger wait” message might be displayed. When pre-triggering is enabled, triggering is ignored until the pre-trigger portion of the waveform has been acquired. Recording starts when a trigger occurs.
Why is the displayed frequency lower than actual frequency on Hioki Camcorder?
If, while measuring with the memory function on your Hioki Camcorder, the displayed frequency is much lower than the actual frequency, aliasing may be occurring. Change the timebase to use a faster sampling rate.
Why displayed waveform size does not change when input range is changed on Hioki 8847 Camcorder?
If the displayed waveform size does not change when the input range is changed on your Hioki Camcorder, the Variable function might be enabled. Turn the Variable function off.
To Next Page
General