Hioki 8847 - Overvoltage Categories (CAT)

Analyze
13
Read measurement value
1. Set the AB cursor.
2
Move
the cursor
Displays the
Waveform screen.
Carry out the following setting by displaying the waveform screen and using the AB cursor setting window.
When trace is set, time value and
measurement value can be seen.
Select
setting items
Displays the AB cursor
settings window.
Kind
Set to [a-B].
Subject Ch
Set to [ALL].
AB cursors
Set to [Trace].
Value of B cursor
Difference between A
cursor and B cursor.
t: Time value
1: Measurement value of CH1
Change the type of AB cursor to display only
the time or measurement values.
Change the AB cursor type.
[V Csr]: Time value and Frequency
[H Csr]: Measurement value
Display
1
Value of A cursor
2. Move the AB cursor to the point you wish to see.
Move the cursor to the point of the measurement value on the waveform you wish to see with the jog
shuttle.
Move the cursor
B cursor moves.
Change the moving cursor
Change moving target ([Kind]) to change the moving
cursor.
[A] : Use and move A cursor only.
[A-b] : Use the AB cursor to move A only.
[a-B] : Use the AB cursor to move B only.
[A&B] : Move both sides simultaneously.
Factory default is set to [A].
Earlier
Later