Analyze
14
When measurements on multi phenomenon are carried out, the waveforms may overlap and become diffi-
cult to see.
When this happens, change the location of the display, or the width of the vertical axis on display to show
the waveforms more clearly.
Display the waveforms without overlapping
The START key is pressed and measurement
has started but the waveforms overlap and
cannot be seen clearly.
Move
the cursor
Displays the Channel
settings window
([Analog] sheet)
Carry out the following settings by displaying the channel setting window in the waveform screen.
Select setting
items
• Can be changed even during measurement.
• Location of logic waveform can also be
changed voluntarily. ([Logic] sheet)
Caution:
When direct current components are loaded on the wave-
form, the waveform appears to fluctuate when the magnifi-
cation is changed. This is because magnification applied to
the direct current component as well.
Zero position
Location of the waveform
can be moved up or down.
Magnification
Waveform can be expanded
or compressed in the direction
of the vertical axis.
To Next Page
Loading...