Hioki BT3562 - Device-Specific Commands

8.6 Message Reference
131
8
Chapter 8 RS-232C/GP-IB/LAN Interfaces
Device-Specific Commands
Set and Query Device-Specific Event Status Enable Registers ESER0
Syntax
Command
:ESE0 <0 to 255>
Query
:ESE0?
Response <0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 0 (ESER0) for
the Event Status Register.
Query Queries the mask pattern in Event Status Enable Register 0 (ESER0)
for the Event Status Register.
Note
Data initializes to zero at power-on.
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
unused unused
ERR
unused unused unused
INDEX EOC
Set and Query Device-Specific Event Status Enable Registers ESER1
Syntax
Command
:ESE1 <0 to 255>
Query
:ESE1?
Response <0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 1 (ESER1) for
the Event Status Register.
Note
Data initializes to zero at power-on.
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
FAIL
AND V-Hi V-IN V-Lo R-Hi R-IN R-Lo
Read Device-Specific Event Status Registers ESR0 and ESR1
Syntax
Query
:ESR0?
:ESR1?
Response <0 to 255 (NR1)>
Note
Executing :ESR0? clears the contents of ESR0.
Executing :ESR1? clears the contents of ESR1.
HIOKI BT3562A981-09