Hioki dt4212 - Page 23

19
Parts Names and Functions
Measurement terminals
DT4211
(Average value measurement model)
DT4212
(True RMS measurement model)
1
1
2
2
3
3
1
1
Current measurement terminal.
Hereafter referred to as “A terminal (A terminal, mA terminal)”.
The red test lead is connected.
2
2
Commonly used for each measurement.
Hereafter referred to as “COM terminal”.
The black test lead is connected.
3
3
Used for voltage measurement, resistance measurement, continuity
check, diode test, temperature measurement, or electrostatic capacity
measurement.
Hereafter referred to as “V terminal”.
The red test lead is connected.
Be sure to carefully read the following precautions for the terminals with the
marking.
• “Precautions during shipment” (p. 13)
• “6.3 Replacing Fuses” (p. 67)