24
Inserting/Replacing Batteries
2.2 Inserting/Replacing Batteries
Before using the instrument for the fi rst time, insert 2 R6P
manganese batteries or LR6 alkaline batteries. Before
measurements, check that the battery level is suffi cient. When the
battery charge is low, replace the batteries.
WARNING
To avoid electric shock, disconnect the test leads from
the object to be measured before replacing the batteries.
To avoid the possibility of explosion, do not short
circuit, charge, disassemble, or incinerate batteries.
After battery replacement but before using the
instrument, reattach and screw down the battery cover.
CAUTION
Poor performance or damage from battery leakage
could result. Observe the cautions listed below.
• Do no mix new and old batteries, or different types of
batteries.
• Be careful to observe the battery polarity during installation.
• Do not use batteries after their recommended expiry date.
• Do not allow used batteries to remain in the instrument.
• To avoid corrosion from battery leakage and/or damage to
the instrument, remove the batteries from the instrument
if it is to be kept in storage for an extended period.
To Next Page
Loading...
