25
Inserting/Replacing Batteries
• lights up when the batteries are exhausted. The accuracy is not
guaranteed. Replace the battery immediately.
• After use, be sure to turn off the instrument.
• Handle and dispose of batteries in accordance with local regulations.
1
Have the following items
available and ready.
• Phillips screwdriver
• R6P manganese battery × 2
or LR6 alkaline battery × 2
2
Remove the test leads from
the instrument.
3
Set the rotary switch to OFF.
4
Remove the holster.
5
Using a Phillips screwdriver
remove the screws (4 locations)
from the battery cover on the
rear of the instrument.
6
Remove the battery cover.
7
Remove all of the old
batteries.
8
Insert 2 new batteries (R6P),
being careful to the battery
polarity.
9
Reattach the battery cover.
10
Secure the cover with the
screw.
11
Reattach the holster.
After the battery cover is removed,
the fuse can be seen. When
replacing the fuse, see “6.3
Replacing Fuses” (p. 67).
Screw
Rear
To Next Page
Loading...
