2.2 Preparing for Measurement
Before using the instrument for the first time, install two AA-size
alkaline batteries (LR6). Verify that there is sufficient battery
power remaining before measurement. If there is insufficient bat-
tery power remaining, replace the batteries.
Installing (or Replacing) the Battery
• To avoid electric shock when replacing the batteries, first
disconnect the clamp from the object to be measured.
• After replacing the batteries, replace the cover and
screws before using the instrument.
• Battery may explode if mistreated. Do not short- circuit,
recharge, disassemble or dispose of in fire.
• Handle and dispose of batteries in accordance with local
regulations
• Do not mix old and new batteries, or different types of batter-
ies. Also, be careful to observe battery polarity during installa-
tion. Otherwise, poor performance or damage from battery
leakage could result.
• To avoid corrosion from battery leakage, remove the batteries
from the instrument if it is to be stored for a long time.
•
The indicator lights when battery voltage becomes
low. Replace the batteries as soon as possible.
• Before replacing the batteries, make sure that the
Slide Switch is OFF.
• After use, always turn OFF the power.
• If the battery is completely exhausted, the display will
show [BAttLo], and the instrument will automatically
turn off.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
