2.5 Insulation Resistance Measurement
2.5.4 Displaying 1-min. Values
The IR4052 provides functionality for automatically holding the
measured value obtained 1 minute after the start of
measurement (after pressing the MEASURE key). The
measured value that is held will be shown on the bottom of the
display. No value is shown if less than 1 minute has elapsed
since the start of measurement. Regardless of the selected
display mode, 1-min. values are always displayed in 1,000 count
display mode.
Use this function when measuring targets that include a
capacitance component.
This function is enabled only when the comparator is
set to “off.”
To Next Page
Loading...
