Commissioning / Service / Maintenance
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 36
24 183 19 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
6.2 Service menus
In this code-protected area, settings affecting system precision can be made by trained service
personnel.
NOTE: This short description is for information purpose only. For detailed description of the
calibration procedure refer to the service manual.
To start the function:
Actuate the INFO key.
to service menu (access is code protected)
back
After entering the service menu you can follow the calibration procedure step by step or can select
the type of calibration by scrolling with function key
. Press "ESC" to finish calibration procedure:
pressure signal
piston side
pressure signal
rod side
slewing angle
signal
boom length signal boom angle
signal
To Next Page
Loading...
