Hirschmann iVISOR mentor QVGA - Error code list

Error code list
© 2009 Hirschmann Automation and Control GmbH · Branch Office Ettlingen · eMail: info.ecs@hirschmann.de · www.hirschmann.com 39
24 183 19 1012e (Generic) / 2009-02-26 / Rev. 01 / rk.
7.2 Error code list (System program LSQN V 1.11)
Error Code Error Cause Elimination
E01
Fallen below radius
range or angle range
exceeded
• Fallen below the minimum
radius or gone past the
maximum angle specified in the
respective load chart due to
luffing up the boom too far
• Luff down the boom to a radius
or angle specified in the load
chart.
E02
Radius range exceeded
or fallen below angle
range
• Gone past the maximum radius
or fallen below the minimum
angle specified in the respective
load chart due to luffing down
the boom too far
• Luff up the boom to a radius or
angle specified in the load
chart.
E03
Non-permitted slewing
zone (no load area)
• The slewing zone with load is
not permitted
• Slew to permitted area
• A non existing operating mode
has been selected
• Set the correct operating mode
for the operating state in
question
E04
Operating mode not
acknowledged or non
permitted slewing zone
• The boom is in a non-permitted
slewing zone
• Slew the boom to a permitted
area.
• Boom has been extended either
too far or not far enough, e.g. if
it is prohibited to go beyond a
certain maximum boom length
or with load curves for jibs
where the main boom has to be
extended to a certain length
• Extend/retract boom to the
correct length
• Length sensor adjustment has
changed, e.g. the cable slid off
the length sensor reel.
• Retract boom. Check the pre-
stress of the cable reel (cable
must be taut). Open the length
sensor and carefully turn the
length sensor pot
counterclockwise until the
detent by means of a screw
driver
E05
Prohibited length range
• Clutch between length sensor
pot and drive is defective
• Replace the complete clutch
including drive wheel and adjust
length sensor pot as described
above
E06
Radius range exceeded
or fallen below angle
range with luffing jib
operation
• Maximum radius as specified in
the load chart exceeded or
fallen below minimum angle
due to luffing down the luffing
jib too far
• Luff the jib to a radius or angle
specified in the load chart.
• Length potentiometer is
defective
• PDB variable for analog value
not supported
• Replace length potentiometer
• Setup of correct PDB variable
for analog value in DGA6.i.3
E11
Fallen below lower limit
value for measuring
channel "length main
boom"
• Electronic component in the
measuring channel is defective
• Replace sensor unit