Setting up the configuration environment
214
A.4
Preparing for access via SSH
Basic - L3P
Release
3.1
06/07
A.4.2 Uploading the key
The Command Line Interface enables you to upload the SSH key to the Switch.
V Store the key file on your tftp server.
V With the command enable, switch to the privileged EXEC mode.
V With the command
no ip ssh
deactivate the SSH function on the Switch, before you transfer the
key to the Switch.
V With the command
copy tftp://149.218.112.159/switch/rsa1.key
nvram:sshkey-rsa1
the Switch loads the key file into its non-volatile memory.
149.218.112.159 represents the IP address of the tftp server.
switch represents the directory on the the tftp server.
rsa1.key is the filename of the key.
V With the command
ip ssh
you reactivate the SSH function on the Switch, after you have
transferred the key to the Switch.
To Next Page
Loading...
Need help?
General
