Entering the IP parameters
Basic - L3P
Release
3.1
06/07
2.4
Loading the system configuration from the
37
2.4 Loading the system
configuration from the ACA
The ACA is a device for
D storing the configuration data of a Switch.
D storing the Switch software.
In the case of a Switch failure, the ACA enables a very simple configuration
data transfer by means of a substitute Switch of the same type.
When you start the switch, it checks for an ACA. If it detects an ACA with a
valid password and valid software, the Switch loads the configuration data
from the ACA.
The password is valid if
D the password on the Switch matches the password on the ACA, or
D the preset password is entered on the Switch.
To save the configuration data in the ACA see “Saving Locally (and on the
ACA)” on page 57
To Next Page
Loading...
Need help?
General
