Installation RSPE30/32/35/37
Release
16
04/2019
53
6Disassembly
6.1 Removing the device
Proceed as follows:
Disconnect the data cables.
Disable the supply voltage.
Disconnect the terminal blocks.
Disconnect the grounding.
Insert a screwdriver horizontally below the casing into the locking gate.
Without tilting the screwdriver, pull the locking gate down and tilt the
device upwards.
WARNING
ELECTRIC SHOCK
Disconnect the grounding only after disconnecting all other cables.
Failure to follow this instruction can result in death, serious injury, or
equipment damage.
To Next Page
Loading...
Need help?
General
