Hisense HSAA16FS - Adjust the Height and Slide the Dishwasher into Place

604
585
50
>90
820-860
【mm】
815-855
573
599
Ÿ When the dishwasher is installed with its worktop, the built-in measurements are shown in the
illustration.
845-885
599
597
604
600
50
>90
850-890
【mm】
Ÿ When the dishwasher is installed in a recess without its worktop, the built-in measurements are
shown in the illustration.
24 mm
Adjust the height and slide the dishwasher into place
• Make sure the area on which the dishwasher is to be installed is firm. Adjust the dishwasher's
height using the four feet so that the dishwasher is level. The dishwasher may lean no more than
5 mm.
Freestanding
Built-in
1. Start by measuring the height from the floor to the bottom edge of the worktop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Adjust the dishwasher's feet by turning them clockwise to raise or anticlockwise to lower the
machine.
4. Check that there is an air gap of at least 3 mm between the underside of the worktop and the top
edge of the dishwasher.
33