Understanding routing by EVS
R
outing by EVS restricts the choice of source addresses available to the
routing engine to those associated with the source EVS. Routing by EVS is
always enabled in multi-tenancy mode. Routing by EVS can also be enabled
when not in multi-tenancy mode.
Some subsystems already use the current EVS to influence routing decisions.
With routing by EVS enabled, many subsystems, such as DNS, which
normally would not use the EVS to influence routing decisions, now would
use routing by EVS. If routing by EVS is to be enabled in non-multi-tenant
mode, it is necessary to use the routing-by-evs-enable command. See the
CLI reference for routing-by-evs commands:
• routing-by-evs-enable
• routing-by-evs-disable
• routing-by-evs-show
Routing overview 29
Hitachi NAS Platform Network Administration Guide
To Next Page
Loading...
