Hitachi 3100

Configuring Aggregate Linux interfaces
T
o view any existing Aggregate Linux interfaces, on the command console,
enter the following command:
aggregate-linux-interface-show
The interfaces appear as shown in the example below:
$ aggregate-linux-interface-show
eth-ag1
$
Creating a new interface
All new Aggregate Linux interfaces must be associated with an existing file
serving link aggregation.
T
o create a new interface, enter the following command:
aggregate-linux-interface-create --interface <interface>
For example:
$ aggregate-linux-interface-create --interface ag1
In this example, the
HNAS server creates an interface named eth-ag1 which
uses ag1 to send and receive management traffic.
Deleting an existing interface
To remove an existing interface, enter the following command:
aggregate-linux-interface-delete <eth-ag-interface>
For example:
$ aggregate-linux-interface-delete eth-ag1
In this example, the
HNAS server deletes an interface named eth-ag1 but
ag1 is not removed.
Configuring link aggregation 43
Hitachi NAS Platform Network Administration Guide