Select the radio button next to the required load balancing scheme.
Editing link aggregations
Use the Edit Link Aggregation Details page to:
•
Remove interfaces from the aggregation
• Add interfaces to the aggregation
• Select an aggregation type: static or LACP
• Change the type of load balancing in use for the aggregation
To edit an aggregation configuration
Procedure
1. Navigate to Network Configuration > Link Aggregation to display
the Link Aggregation page, which lists all currently configured
aggregations.
2. Click details to display an aggregation’s Link Aggregation Details page.
3. The Assigned Ports field lists the interfaces currently assigned to this
aggregation. To remove an interface from the aggregation, deselect the
check box next to the name of the interface.
4. The Available Ports field lists the available ge (gigabit Ethernet) and tg
(10 GbE) interfaces that can be added to the aggregation. To add an
interface to the aggregation, select the check box next to the name of
the interface.
5. The Use LACP field specifies whether the aggregation uses LACP. Select
Yes in order to use LACP. An aggregation that does not use LACP is
called a static aggregation, and an aggregation that does use LACP is
called a dynamic aggregation.
6. Select a Port load balancing scheme in the Port level load balancing
field. The options are Normal and Round robin.
7. Click OK to save the changes, or click cancel to return to the Link
Aggregation page without saving the changes.
Deleting link aggregations
Caution: Before deleting an aggregation, remo
ve all IP addresses, ge and tg
interfaces associated with the aggregation.
To delete an aggregation
Configuring link aggregation 41
Hitachi NAS Platform Network Administration Guide
To Next Page
Loading...
