19. Controller Configuration window is displayed. Select Controller
Properties, and then press Enter key.
20. Controller Properties window is displayed. Confirm and record Boot
Support.
21. Press Esc key.
22. Controller Configuration window is displayed. Select Network
Configuration, and then press Enter key.
23. Network Configuration window is displayed. Select Configure Static
IP Address, and then press Enter key.
24. Static IP Address window is displayed. Confirm and record IP Address,
Subnet Mask and Default Gateway.
25. Press Esc key.
26. Controller Configuration window is displayed. Select iSCSI Target
Configuration, and then press Enter key.
27. iSCSI Target Configuration window is displayed. Select Add New
iSCSI Target, and then press Enter key.
Note: The iSCSI Target Name may not be fully indicated in the dialog
box.
Move cursor to right by using → key to confirm the last character.
7-62
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
