• Updating the firmware
•
Restarting BMC
• Changing IP address of BMC
When the remote console is disconnected while using the virtual media, the
data may not read/write properly, or the eject button on the CD/DVD drive
may not work properly. Exit the virtual media console before the above
operation.
For avoiding the eject button problem, see
Troubleshooting problems on page
4-2.
Remote console window after OS shutdown or server blade power off
The server blade VGA screen that is displayed before powering off may be
kept to display after the OS shutdown or server blade power off, instead of
displaying "No Signal" on the remote console. If "No Signal" is not displayed,
confirm that the power status shown in the lower right corner of remote
console window is Power OFF.
Remote console behavior with unsupported Java VM
Multiple Java VM versions can be installed on a system console. If any other
Java VM version than those described in Requirements for a system console
on page 1-3, such as a version made by another vender, is installed, the
Remote console overview
1-9
Hitachi Compute Blade 500 Series Remote Console User's Guide
To Next Page
Loading...
