Intended Audience
This document is intended for the personnel who are involved in planning,
managing, and performing the tasks to prepare your site for Compute Blade
installation and to install the same.
This document assumes the following:
•
The reader has a background in hardware installation of computer
systems.
• The reader is familiar with the location where the Compute Blade will be
installed, including knowledge of physical characteristics, power systems
and specifications, and environmental specifications.
Product Version
This document revision applies to management module firmware A0240.
Release Notes
Release notes contain requirements and more recent product information that
may not be fully described in this manual. Be sure to review the release notes
before installation.
Document Organization
The table below provides an overview of the contents and organization of this
document. Click the chapter title in the left column to go to that chapter. The
first page of each chapter provides links to the sections in that chapter.
Chapter Description
Chapter 1, Remote console overview Describes an overview of the remote console.
Chapter 2, Using the remote console Provides information on using the remote console.
Chapter 3, Using the virtual media Provides information on using the virtual media
operation.
Chapter 4, Troubleshooting Describes troubleshooting for the remote console.
Chapter 5, End User License Describes troubleshooting for the remote console.
Referenced Documents
•
Hitachi Compute Blade 500 Series Management Module Setup Guide,
MK-91CB500014
• Hitachi Compute Blade 500 Series Server Blade Setup Guide,
MK-91CB500012
vi
Preface
Hitachi Compute Blade 500 Series Remote Console User's Guide
To Next Page
Loading...
Need help?
General