17
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY BUTTON
POSITION
12
ESC
ENTER
MENU
RESET
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
VOLUME
ON
OFF
㧗
FREEZE
FOCUS D-ZOOM
- + - +
LAMP
TEMP
POWER
STANDBY/ON
INPUT
Power on/off
Turn off the power
Turn the projector off after turning off the other connected devices, unless
mentioned in the manuals. For this projector, follow the procedure below.
When you will not use the projector for a long while, unplug and separate the
power cord from the power outlet, for safety purposes.
Power
switch
STANDBY/ON button
1.
Press the STANDBY/ON button (on the
projector or remote control).
The “Power off?” dialog appears on the
screen for about 5 seconds.
2.
Confirm that there is nothing that the lens
door hits while closing.
Then press the STANDBY/ON button again
while the message appears.
The projection lamp goes off, the lens door
closes, and the POWER indicator begins to
blink orange.
3.
Press the side marked " " of the power switch, as the power-off position.
The POWER indicator goes off.
• Use the shutdown switch (67) only when the projector is not turned
off by normal procedure.
• Do not turn the projector on for about 10 minutes or more after turning it off.
Turning the projector on again too soon could shorten the lifetime of some
consumable parts of the projector.
NOTE
►Be careful not to pinch your finger with the lens door, to
prevent an injury.
►Do not touch the lamp cover or approach the exhaust vents while using the
projector and for a while after use, to prevent a burn.
CAUTION
POWER indicator
STANDBY/ON button
● For cooling the projector down, wait for the
POWER indicator to stop blinking and turn
steady orange.
The projector can be turned off without
waiting for cooling down. However, the
manufacture recommends cooling the
projector down enough.
Do not turn the projector on for about 10
minutes or more after turning it off to prevent
shortening its life.
To Next Page
Loading...
Need help?
General