37
Item Description
PERFECT FIT
This item allows you to adjust the shape of the projected image in
each of the corners and sides.
(1) Choose a corner or side to adjust
using the ▲/▼/◄/► buttons and
press the ENTER or INPUT button.
(2) Adjust the distortion as below.
Use the ▲/▼/◄/► buttons to adjust
the position of the corner.
Use the ▲/▼ buttons to adjust the
distortion of the top or bottom side,
after defining the adjusting position
with
the
◄/► buttons.
Use the ◄/► buttons to adjust the distortion of the left or right side,
after defining the adjusting position with the ▲/▼ buttons.
(3) To adjust another corner or side, follow the same procedure
from (1) above.
To reset the adjustment of all the corners and sides, select RESET
with the ▲/▼ buttons and press the ENTER or INPUT button.
• While the distortion is adjusted with the PERFECT FIT function,
keystone adjustment feature is unavailable. To correct the keystone
distortion, reset the adjustment of all the corners and sides.
• The adjustable range of this correction will vary among inputs. For
some input, this function may not work well.
• One adjustment position common to the top and bottom sides can
be set. Also, another adjustment position common to the left and
right sides can be set.
• The distortion of the top and bottom sides can be adjusted only in
the same direction, pincushion or barrel. The adjustment for the left
and right sides is carried out in the same manner.
• This function will be unavailable when the Transition Detector is
on (
54).
WHISPER
Using the ▲/▼ buttons turns off/on the whisper mode.
NORMAL WHISPER
• When WHISPER is selected, acoustic noise and screen brightness
are reduced.
MIRROR
Using the ▲/▼ buttons switches the mode for mirror status.
NORMAL H:INVERT V:INVERT H&V:INVERT
If the Transition Detector is TURN ON and MIRROR status is
changed, Transition Detector Alarm (
54) will be displayed when
projector is restarted after the power switch is turned off.
SETUP menu
SETUP menu (continued)
(continued on next page)
To Next Page
Loading...
Need help?
General