Hitachi CP-X260 User Manual

10
Setting up
Using the Security Bar
WARNING Ź'RQRWXVHWKHVHFXULW\EDUWRSUHYHQWWKHSURMHFWRUIURP
falling. Dropping or knocking over the projector may cause damage or injury.
A commercial anti-theft chain or wire can be attached to the security bar on the
projector.
1.
How to attach
An anti-theft chain or wire can be
attached as shown in the illustration.
(Anti-theft chains or wires of up to
10mm in diameter can be used)
Anti-theft chain or wire
[sold separately]
Security Bar
CAUTION Ź7KHVHFXULW\EDULVQRWDFRPSUHKHQVLYHWKHIWSUHYHQWLRQ
measure. It is intended to be used as an extra theft prevention measure.

Hitachi CP-X260 Specifications

General

Number of colors	16.78 million colors
Projection technology	LCD
Contrast ratio (typical)	500:1
Digital gamma correction	Yes
Projector native resolution	XGA (1024x768)
Aspect ratio	4:3, 16:9
RS-232 ports	1
Power requirements	AC100-120V/AC220-240V; 50/60Hz
Horizontal resolution	540 lines
Lamp type	UHB
Lamp power	200 W
Light source type	Lamp
Service life of light source	3000 h
Analog signal format system	NTSC, PAL, SECAM
RMS rated power	1 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
VGA (D-Sub) ports quantity	3
Noise level	39 dB
Power consumption (typical)	310 W
Operating temperature (T-T)	5 - 35 °C