Hitachi CP-X260 User Manual

14
Connecting power supply
WARNING ŹPlease use extra caution when connecting the power cord, as
LQFRUUHFWRUIDXOW\FRQQHFWLRQVPD\UHVXOWLQ¿UHDQGRUHOHFWULFDOVKRFN
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet rated for use with the power cord's
VSHFL¿HGYROWDJHUDQJH
• Never modify the power cord. Never attempt to defeat the ground connection
of the three-pronged plug.
1.
Connect the connector of the power cord to the AC inlet of the projector.
2.
Firmly plug the power cord's plug into the outlet.
Setting up
AC inlet
Connector
of the power cord

Hitachi CP-X260 Specifications

General

Number of colors	16.78 million colors
Projection technology	LCD
Contrast ratio (typical)	500:1
Digital gamma correction	Yes
Projector native resolution	XGA (1024x768)
Aspect ratio	4:3, 16:9
RS-232 ports	1
Power requirements	AC100-120V/AC220-240V; 50/60Hz
Horizontal resolution	540 lines
Lamp type	UHB
Lamp power	200 W
Light source type	Lamp
Service life of light source	3000 h
Analog signal format system	NTSC, PAL, SECAM
RMS rated power	1 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
VGA (D-Sub) ports quantity	3
Noise level	39 dB
Power consumption (typical)	310 W
Operating temperature (T-T)	5 - 35 °C